Lash Care

As our lashes are re-usable it is important to look after them properly. This ensures you get the maximum number of uses from each set. 

When removing the lashes from the tray for the first time be gentle to avoid damage to the lash band. Start from the outer "tab" on the lash band. 

Application:

First you will need to measure your lashes to the length of each eye lid. This will show you if the lash needs to be trimmed. Trim using a small scissors. Also trim the tabs from either side of the lash carefully to ensure the lashes are comfortable to wear. Once the lash is the correct size apply a small amount of glue (I recommend Duo Glue) along the lash band only. Allow to sit for 60-90seconds so the glue can get tacky. Then apply to the base of your own lashes. I personally use a tweezers for application as I find it easier but you can also use your fingers. Once you have applied them to the base of your own lashes you will need to press the lashes together to bond with your own lashes to prevent any gaps being seen between the false lash and your own natural lashes.

Tip: 

Always apply mascara to your own lashes before applying Rebeluna lashes as mascara can damage the false lashes. It is important to apply mascara as this will blend your own lashes with the false lashes.

Removing Rebeluna Lashes:

To remove safely simply apply a water based (oil free) eye make up remover to a cotton bud, roll gently across the eye lid for a few seconds to loosen the lashes. We do not recommend peeling the lashes off without having loosened the adhesive as this may cause damage to the natural lashes on the eye lid. Once the glue has loosened you can remove the lashes.

Cleaning Rebeluna Lashes:

As the lashes are re-usable it is important to keep them clean over time. This ensures the lashes are hygienic to use on the eye area and also gives you the best chance of getting the maximum number of wears from each set.

Soak a cotton bud in an oil free make up remover (such as Bio Derma Micellar Water). Gently roll along the lash band to loosen the glue. Very gently remove the excess glue using a tweezers taking extreme care to avoid damaging the lash band. Allow lash band to dry for a few minutes. Once the lash band is dry place lashes back on the tray and into the box ready for the next use.